Abstract
An experimental study of amplitude modulation (AM) and phase modulation (PM) noise spectra in cascaded amplifiers was carried out as a function of the number of amplification stages and the input power. Flicker and white noise contributions were determined, as well as effective noise figure (NF) from AM and PM noise spectra from small-signal to large-signal regimes. Simultaneous measurements of AM and PM noise were performed, and associated correlation was measured as a function of the offset frequency from the carrier. Measurements exhibited, in general, quite low AM–PM correlation levels both in the flicker and white noise parts of the spectrum. In some particular amplifier configurations, however, measurements showed some peaks in the correlation at some specific input power levels in the transition zone, from a quasi-linear to strong compression. The results show that the effective noise figure decreases with the number of stages for a given carrier output power level.