Search
Now showing items 1-10 of 13
Supercapacitor Electro-Mathematical And Machine Learning Modelling For Low Power Applications
(MDPI, 2018-03-29)
Low power electronic systems, whenever feasible, use supercapacitors to store energy instead of batteries due to their fast charging capability, low maintenance and low environmental footprint. To decide if supercapacitors ...
Multiple current amplifier-based gate driving for parallel operation of discrete SiC MOSFETs
(Wiley, 2022-03)
The shorter switching times of silicon carbide (SiC) MOSFETs enable power converters to operate at higher frequencies than with silicon IGBTs. However, because SiC MOSFET die sizes are still relatively small, several devices ...
Mini Wind Harvester and a Low Power Three-Phase AC/DC Converter to Power IoT Devices: Analysis, Simulation, Test and Design
(MDPI, 2020-09-11)
Wind energy harvesting is a widespread mature technology employed to collect energy, but it is also suitable, and not yet fully exploited at small scale, for powering low power electronic systems such as Internet of Things ...
Photovoltaic Energy Harvesting System Adapted for Different Environmental Operation Conditions: Analysis, Modeling, Simulation and Selection of Devices
(MDPI, 2019-04-01)
The present research work proposes a photovoltaic energy harvester and an appropriate direct current (DC)/DC converter for a harvesting system after the study of the devices and taking the operation conditions. Parameters ...
Medical Devices with Embedded Sensor Systems: Design and Development Methodology for Start-Ups
(MDPI, 2023-02-26)
Embedded systems have become a key technology for the evolution of medical devices. However, the regulatory requirements that must be met make designing and developing these devices challenging. As a result, many start-ups ...
Embedded Sensor Systems in Medical Devices: Requisites and Challenges Ahead
(MDPI, 2022-12-16)
The evolution of technology enables the design of smarter medical devices. Embedded Sensor Systems play an important role, both in monitoring and diagnostic devices for healthcare. The design and development of Embedded ...
A Survey on IEEE 1588 Implementation for RISC-V Low-Power Embedded Devices
(MDPI, 2024-01-22)
IEEE 1588, also known as the Precision Time Protocol (PTP), is a standard protocol for clock synchronization in distributed systems. While it is not architecture-specific, implementing IEEE 1588 on Reduced Instruction Set ...
Analysis of DC–DC power supply systems for pulsed loads from green electronics perspective
(The Institution of Engineering and Technology, 2015-06-01)
Discontinuous loads frequently compromise the performance of their power source and electronics. They cause the voltage and current ripple at the source and load, and introduce electromagnetic interferences. Also, they ...
Energy Harvesting Technologies and Equivalent Electronic Structural Models - Review
(MDPI, 2019-04-25)
As worldwide awareness about global climate change spreads, green electronics are becoming increasingly popular as an alternative to diminish pollution. Thus, nowadays energy efficiency is a paramount characteristic in ...
PRP and HSR for High Availability Networks in Power Utility Automation: A Method for Redundant Frames Discarding
(IEEE, 2015-01-21)
Critical systems require zero recovery time when a failure occurs in a communications network. The soon to be implemented standard IEC 62439-3 defines the only two protocols, parallel redundancy protocol and high-availability ...