Biodegradable binary blends of poly (butylene succinate) or poly (ε-caprolactone) with poly (butylene succinate-ran-ε-caprolactone) copolymers: Crystallization behavior
Ver/
Fecha
2022-08-12Autor
Safari, Maryam
Pérez Camargo, Ricardo Arpad
Ballester Bayarri, Laura
Mugica Iztueta, Miren Agurtzane
Zubitur Soroa, María Manuela
Wang, Dujin
Liu, Guoming
Metadatos
Mostrar el registro completo del ítem
Polymer 256 : (2022) // Article ID 125206
Resumen
Poly (butylene succinate) (PBS) and polycaprolactone (PCL) are two immiscible biocompatible and biodegradable polymers. Aiming to combine the properties of these biodegradable polymers, this work explores for the first time blending PBS or PCL with PBS-ran-PCL copolymers (BSxCLy) at 75/25, 50/50, and 25/75 wt% compositions, with various copolymer contents: BS78CL22, BS46CL54, and BS15CL85. The crystallization behavior of these novel binary blends was systematically studied with non-isothermal and isothermal differential scanning calorimetry (DSC), polarized light optical microscopy (PLOM), and simultaneous wide- and small-angle X-ray scattering (WAXS and SAXS). All the blends displayed a miscible character in the amorphous state, judging by a single glass transition temperature, and in the melt state (as indicated by SAXS), but their miscibility in the crystalline state depends on the specific blend. In both PBS/BS78CL22 and PCL/BS15CL85 evidences of co-crystallization between the matrix and the crystallizable fraction of the copolymer were found. However, high comonomer exclusion, higher in the BS15CL85 than in the BS78CL22, greatly affects blend miscibility. Thus, the results show that the PBS/BS78CL22 blend is miscible, in the crystalline state, at high PBS (homopolymer) content, i.e., 75/25 and 50/50 compositions, whereas its “counterpart”, the PCL/BS15CL85 displays partial miscibility, even for high PCL (homopolymer) content. For the 25/75 blends, i.e., copolymer-rich, the homopolymer addition favors the crystallization of the copolymer-rich component. Blending PBS or PCL with BS46CL54 leads to blends that exhibit a much lower miscibility in the crystalline state than the blends prepared with BS or CL-rich copolymers, independently of the composition. But, interestingly, a novel behavior is found, since the BS46CL54 copolymer can crystallize either in PBS type crystals or in PCL type crystals depending on the polymeric matrix (PCL or PBS). The PBS favors the crystallization of the BS component, while the PCL favors the crystallization of the CL component within the random copolymer. The crystallization behavior found in this work evidences the interactions of the PBS or PCL with the BSxCLy copolymer, representing a potential strategy to combine the properties of the PBS and PCL through blending.